Concentrations of hazardous heavy metals in environmental samples collected in Xiamen, China, as determined by vapor generation non-dispersive atomic fluorescence spectrometry.

Non-dispersive atomic fluorescence spectrometry (NDAFS) coupled with vapor generation (VG) sample introduction was applied to the determination of the concentrations of hazardous heavy metals, such as arsenic, cadmium, lead and mercury, in seawater, soils and total airborne particulate matter (PM) collected around the Xiamen area in China. Almost 100% sample introduction efficiency was achieved by using thiourea and ascorbic acid for the pre-reduction of As(V) to As(III), K3Fe(CN)6 and tartaric acid for pre-oxidation of Pb(II) to Pb(IV), and masking the interferences arising from the co-existing transition metals to As, Cd, Hg and Pb during their vapor generation process. Moreover, a novel sample pretreatment device was developed to avoid the loss of mercury, lead, cadmium and arsenic during sample pretreatment. With such methods, the detection limit (DL) of arsenic, cadmium, lead and mercury was down to 0.08, 0.03, 0.05, 0.01 ng mL(-1) (3sigma), respectively. The relative standard deviations (RSD, n = 11) for arsenic, cadmium, lead and mercury at 10 ng mL(-1) were 0.9%, 1.6%, 1.3% and 2.0%, respectively. The concentrations of hazardous heavy metals in the environmental samples collected in Xiamen, China are in the range from 0.02 +/- 0.001 ng mL(-1) in seawater to 15.3 +/- 0.2 microg g(-1) in soils. Besides flame/GF-AAS and ICP-AES/MS, VG-NDAFS should be another choice for the determination of hazardous heavy metals in environmental samples.     

基于Apollo信号控制台的NQR炸药探测方法

介绍了一种基于Apollo信号控制台的核四极矩共振（NQR）炸药探测方法，描述了系统的结构组成、工作原理和实现方法，并给出了对RDX的测试试验结果. 试验表明该方法可实现对RDX信号的探测.     

掺杂偶氮苯聚合物光致异构Z扫描测量及其理论解释

用He_Ne激光对掺有偶氮苯聚合物DR 13的PMMA薄膜样品进行Z扫描研究 ,发现其折射率改变量与光强的关系存在着饱和效应 ,且线偏振光引起的折射率改变明显大于圆偏振光引起的折射率改变 .对于这些现象 ,用光致异构的角烧孔机理进行解释     

Yb~(3+)∶Pr~(3+)∶ZBLAN光纤中4f5d上转换激发的理论研究

利用粒子数速率方程和相关的辐射跃迁理论,计算了Yb3+∶Pr3+∶ZBLAN光纤中Pr3+离子4f5d能级两步上转换激发的动力学过程。得到不同Pr3+掺杂浓度下,激发光的光谱强度和粒子数密度的纵向分布和有效光纤长度随激发光的光谱强度的变化关系。另外,还得到了4f5d荧光强度与入射光强、光纤长度和Pr3+掺杂浓度的关系,给出了激发效率与激发光的光谱强度和Pr3+掺杂浓度的关系。     

横向射流式单重态氧发生器的性能实验研究

 对氧碘化学激光器的单重态氧发生器（SOG）进行了改进，采用横向射流方式，并对该横向射流式单重态氧发生器的性能进行了检测。实验中过氧化氢碱溶液温度控制在－16℃左右,氯气流量为530mmol/s，He与氯气的流量比为3;采用PS法测量单重态氧分子的产率,吸收法测量氯气的利用率和相对水含量。得出如下结论:在不使用冷阱和分离器的情况下，最高单重态氧分子产率达到58%, 氯气利用率在80%以上,相对水含量小于等于0.5;气体达到最大流量时,发生器仍然能稳定地工作。     

Synthesis of Cationic PEM Emulsion and Application in Waste Water Treatment

Cationic polymer as a kind of flocculant is widely applied in purification treatment of waste water. Because it has positive charge group, it is able to connect strongly the suspended matters, short cellulose and other microparticles. The research on synthesis of cationic polymer and application in treatment of waste water is very universal abroad. But domestic research on those is not general. The technology of synthesis of PEM is simple, and the production cost is low. It is easy to apply in treatment of waste water.Synthesis of PEM Emulsion FlocculantSome distilled water, PVA(poly(vinyl alcohol)), EA(ethyl acrylate), and K2S2O8(potassium persulfate) were put into reaction vessel. Kept stirring up under nitrogen. When heated the solution to 40℃, dropped the water solution of MTA[(2-methacryloxylethyl)trimethyl ammonium].Maintained the temperature at 70℃, reacted about 7-8 hours. Then got the PEM emulsion. Changed the ratio of EA and MTA. Obtained a series of PEM emulsions.Stability and Convertibility of PEM EmulsionThe test results showed that when the EA/MTA was 85/15, the PEM emulsion was most stable.When the total monomer quantity was 35%, the convertibility of PEM emulsion was the highest,i.e.98.6%.The MTA Copolymerization Ratio and Morphology of PEM EmulsionWhen the monomers EA/MTA=85/15 and total monomer quantity was 35%, the MTA copolymerization ratio of PEM emulsion was 95.15%(the highest), and the PEM emulsion was some microspheres with 100-180nm of diameter.The Test Results of PEM Emulsion in Treatment of Waste Water The PEM emulsion flocculant was applied in treatment of waste water of paper mill, and measured the precipitation time(t) and transmittancy(T). The test results were showed in table 1. The optimum value of PEM which was able to make the waste water of paper mill into clear water was 0.008%.     

The Crystal Structure of N-Benzoyl-N''-(2-hydroxyethyl)-thiourea

Thiourea compounds are excellent agents of bioactive substance. A number of biological activities are associated with substituted thiourea derivatives. A survey of literature reveals that some work has been reported on benzoylthiourea, which has found plenty of applications as a facile and simple ligand in determination of trances of the transition metal and as an available starting material in preparation of a wide variety of metal complexes. In recent years,N-benzoyl-N'-(2-hydroxyethyl)-thiourea has attracted considerable attention as selective reagents for the liquid-liquid extraction and preconcentration of platinum group metals and its antifungle activity.As a part of our works in studying coordination behaviours of N-benzoyl-N'-(2-hydroxyethyl)-thiourea and its bioactivity, in view of these observations and in continuation of our previous works on it, the present work was reported on the crystal structure of N-benzoyl-N'-( 2-hydroxyethyl)-thiourea.The crystals structure in the monoclinic system and space group of P21/c of N-benzoyl-N'-(2-hydroxyethyl)- thiourea (C10H12N2O2S) was determined from single-crystal X-ray diffraction analysis, a = 17.083 (3) A, b = 4.5490 (10) A, c = 14.279 (3)A, a = 90.00°, a = 102.44(3)°, a = 90.00 °, Ⅴ = 1083.6 (4)A3, Z = 4, Dc = 1.375 Mg/m3, i (Mo Ka)= 0.280 mm-1, F(000) =472. The final R and u R are 0.0399 and 0.0881 for 783 observed reflections [Ⅰ＞26(Ⅰ)].Fig. 1 shows the molecular crystal structure of N-benzoyl-N'-(2-hydroxyethyl)thiourea indicating that the carbonyl and thiocarbonyl moieties are pointing in approximate opposite directions. The six atoms in the ring structure hydrogen bonded are almost in one plane. The N(2)-H proton pendant arm extends to the carbonyl oxygen atom, forms hydrogen bond between them.The existence of hydrogen bond in benzoyl-thiourea molecular six-membered ring structure has significant implications on coordination properties, suggest the possibility of intramolecular hydrogen bond controlled coordination behaviors of these potentially bidentate ligands. In the coordination compound reported by Bourne et al.,cis-bis(N-benzoyl-N'-propylthiourea)dichloroplatinum(Ⅱ), the two ligand molecules bind to Pt(Ⅱ)via the sulfur atoms only, the carbonyl oxygen atom being locked into hydrogen bond similar to that in the free ligands.     

The Research on Polymer Microcapsulation for Cell Technology

Microcapsulation is a technology that enwrapped the solid or liquid or some gas matter with membrane materials to form microparticles(i.e.microcapsules). The materials of microcapsule is composed of naturnal polymers or modified naturnal polymers or synthesized polymers. The water-soluble core matter can only use oil-soluble wall materials, and vice versa.Synthesized methods of polymer microcapsulesSynthesized methods with monomers as raw materialsThis kind of methods include suspension polymerization, emulsion polymerization, dispersal polymerization, precipitation polymerization,suspension condensation polymerization, dispersal condensation polymerization, deposition condensation polymerization, interface condensation polymerization, and so on.Synthesized methods with polymers as raw materialsThese methods are suspension cross-linked polymerization, coacervation phase separation,extraction with solvent evaporation, polymer deposition, polymer chelation, polymer gel,solidification of melting polymer, tray-painted ways, fluidized bed ways, and so forth.Polymer materials to synthesize microcapsules2.1. Naturnal polymer materialsThe characteristics of this kind of materials are easy to form membrane, good stability and no toxicity. The polymer materials include lipids(liposome), amyloses, proteins, plant gels, waxes, etc.2.2. Modified polymer materialsThe characteristics of these materials are little toxicity, high viscidity(viscosity), soluble salt materials. But they cannot be used in water, acidic environment and high temperature environment for a long time. The materials include all kind of derivants of celluloses.2.3. Synthesized polymer materialsThe characteristics of the materials are easy to form membrane, good stability and adjustment of membrane properties. The synthesized polymer materials include degradable polymers(PLA, PGA,PLGA, PCL, PHB, PHV, PHA, PEG, PPG and the like) and indegradable polymers(PA, PMMA,PAM, PS, PVC, PB, PE, PU, PUA, PVA and otherwise).The applications of polymer microcapsules in cell technologyThe "artificial cell" is the biological active microcapsule used in biological and medical fields.The applications of cells (including transgenic cells, the same as artificial cells) technology include several aspects as follows:3.1. Microcapsulation of artificial red cell3.2. Microcapsule of artificial cell of biological enzyme3.3. Microcapsule of artificial cell of magnetic material3.4. Microcapsule of artificial cell of active carbon3.5. Microcapsule of active biological cell     

Crystal Structures of Two Potential Tumor Imaging Agents and Therapeutic Agents Copper（Ⅱ） Ternary Complexes with Salicylidene-tyrosinato Schiff Base and Nitrogen-donor Chelating Lewis Base

The crystal structures of two potential tumor imaging agents and therapeutic agents -copper(Ⅱ) complexes with salicylidene-tyrosinato Schiff base and nitrogen-donor chelating Lewis base, [Cu(sal-tyr)(bipy)] 1 and [Cu(sal-tyr)(phen)]2CH3OH 2 are presented. Our work is helpful to get deep understanding of novel 64Cu tumor imaging agents and therapeutic agents.     

}MSo浸种对大麦种子萌发及若干性状的影响

本文报道二甲亚矾(DMSO)浸种影响大麦“早熟3号”种子的萌发以及浸种后种子的渗漏和呼吸强度等的变化.结果表明:在24℃条件干浸种，。.1%和5芳的DMSO明显促进种子的萌发，5劣DMSO浸种的促进作用尤为明显.然而这种影响效应在zs c条件下浸种则完全相反，对种子萌发有抑制作用，表现明显的温度效应.